This bearing system enables the designer to enjoy the low friction of PTFE at a bearing point temperature above the use limit (500°F) of PTFE.
These bearings provide a coefficient of friction less than 3% at a design pressure of 2500 psi (max.) with little variation at lesser pressures.
These bearings provide a coefficient of friction less than 3% at a design pressure of 2500 psi (max.) with little variation at lesser pressures.
The bearings can be installed with a stitch weld 1/2 inch long 3 inch on center on all sides. The upper and lower units must be backed up with structural plates so that a uniform load is transmitted into the unit. Bending of the units is unacceptable.
Unit of Measure
Element |
N/A Upper |
Max. Use Temperature (°F) |
N/A 1000 |
Design Pressure (psi) |
N/A 2500 |
Coefficient of Friction |
N/A < 3% |
